17
1. The smell of gas in conjunction with extreme yellow tipping of burner flames.
2. Heater does not reach proper temperature.
3. Heater’s glow is excessively uneven.
4. Burner makes popping noises during use.
Note: A slight pop is normal when burner is extinguished.
i. Carbon deposits may create a fire hazard. Keep dome and emitter clean at all times.
j. Do not clean heater with combustible or corrosive cleaners. Use warm, soapy water.
k. Do not paint engine, engine access panel or dome.
l. This heater should be thoroughly cleaned on a regular basis.
m. After a period of storage and/or non use, check for leaks, burner obstructions and
inspect for any abrasion, wear, cuts to the hose.
Cleaning
a.
Wipe surfaces clean with mild dish detergent or baking soda.
b.
For stubborn surfaces use a citrus-based degreaser and a nylon scrubbing brush.
c.
Rinse clean with water.
Note: While cleaning the unit, be sure to keep the area around the burner and pilot
assembly dry at all times. Do not submerge the control valve assembly. If the gas
control is submerged in water, do NOT use it. It must be replaced.
TIP: Use high-quality automobile wax to help maintain the appearance of the
heater. Apply to exterior surfaces from the pole down. Do not apply to emitter
screen or domes
Maintenance
a.
Keep exterior surfaces clean.
b.
Air flow must be unobstructed. Keep controls, burner and circulating air
passageways clean.
Signs of possible blockage include:
Gas odor with extreme yellow tipping of flame.
Heater does NOT reach the desired temperature.
Heater glow is excessively uneven.
Heater makes popping noises.
Note: In a salt-air environment (such as near an ocean) corrosion occurs more quickly
than normal. Frequently check for corroded areas and repair them promptly.
Storage
Between uses or during periods of extended inactivity:
a.
Turn control knob to "OFF".
b.
Disconnect LP cylinder and move to a secure, well-location outdoors.
c.
Store heater upright in an area sheltered from direct contact with inclement weather
(such as rain, sleet, hail, snow, dust and debris).
Note: Never leave LP gas tank exposed to direct sunlight or excessive heat.
d.
If desired, use cover (K) to protect the heater and help prevent buildup in air
passages.
CAUTION: Wait until heater is cool before covering.
Summary of Contents for 640-08477458-7
Page 19: ......