Page 2
2. Open frame by pushing down on the hinged folding mechanism so
that the hinged bar is level.
SET UP INSTRUCTIONS
3. Insert the backrest, handles and tote.
(a)
To insert the backrest, push pins on the outside of the backrest
and insert backrest into the brackets on the front of the walker
frame. Once properly installed, the backrest should click into
place and the pins should protrude into the holes.
(b)
Unscrew the bolts and height adjustment knobs from handles
and insert handles into the frame of the walker while making
sure the cables are on the outside of the frame.
(c)
Adjust the handle height as directed by your physician,
physical therapist or trained professional. Insert the bolt from
inside of the frame so that the hex head fits snugly into the six
sided hole.
(d)
Firmly screw the knob until fully tightened, making sure that the
bolt head is still securely recessed into the frame.
(e)
Place the tote under the seat of the walker, between the frame
tubes. Secure the tote with the snap button flaps.
Vinyl Tote
Height Adjustment
Knobs (2) With
Bolt Attached
Hinged Folding
Mechanism
Loop Brakes Handles
are attached to the
Frame by Cables (2)
Backrest
Backrest
Receiving
Tube
Serial No. Label
on back
(Silver label, number
starts with “RM-E”)
4. Be sure all attached hardware is tightened securely.
