INSTALLATION
10
11. Remove the top cover plate from the
top left corner of the unit and transfer
it to the corresponding position on the
opposite side.
12. Re-attach the upper door and ensure
the middle hinge upper pin is properly
positioned in the bottom bushing (hole)
of the upper door.
13. Reverse the top hinge 180° and re-attach
the hinge and bolts to the opposite side
of the unit. Ensure that the top hinge pin
is properly positioned in the top bushing
(hole) of the upper door. Ensure that the
upper door is properly levelled.
14. Replace the refrigerator lid and 4 screw
caps.
15. With the doors closed, check that the
doors are aligned horizontally and
vertically and that the seals are closed
on all sides before finally tightening all
hinges. Re-adjust the levelling feet as
needed.
10. Reverse the middle hinge 180° and
re-attach the hinge and flange screws to
the opposite side of the unit. Ensure that
the middle hinge lower pin is properly
positioned in the top bushing (hole) of
the lower door. Tighten the middle hinge
and flange screws.