42
Single shot firing
The single shot trigger requires you to perform firing in a particular
sequence:
13. Press the gun's nose against the material so that the safety
arm slides in.
14. Squeeze the trigger - the nail is fired.
15. Lift the gun from the material so that the safety arm travels
out.
16. Release the trigger.
The gun is now ready for a new cycle.
Contact firing
Hold the trigger with a firm grip. Press the gun's nose against the
material so that the safety arm slides in. A nail is fired on each
new contact. When nailing is complete, the trigger should be
released to prevent unwanted firing. Never carry the gun with the
trigger depressed!
Note!
Contact firing must never be activated when working on
scaffolding, ladders or on stairs, nor if the user is walking around.
On guns equipped with quick-changing, select the setting single
(T) or contact firing (TTT). Press out and turn the adjusting
knob/dial button in the trigger so it points toward the desired
symbol.
16.2.
Daily maintenance/rules of conduct
Check that the compressed air is correct before starting. The
maximum air pressure is given on the tool.
Keep the magazine and the loading mechanism clean.
Before starting, check that the tool is loaded with the right
nails. Only use those recommended by the manufacturer.
Drain the compressor tank and water separator daily.
Ensure that all screws on the tool are properly tightened.
Lubricate the tool with acid-free tool oil.
Disconnect the air supply and empty the magazine after work.
Check that the magazine is properly secured.
In the event of abnormal function, disconnect the air supply
immediately.
Summary of Contents for 7317761049708
Page 1: ......
