8.
Apply wood glue as shown.
9.
Cover the top sheet(W29-32).
Hold down the front edge with pins to the sub leading edge.
10.
Weigh down with magazine as shown.
11.
Insert wing dowels and glue.
FUSELAGE
1.
Glue fuselage side sheets(F1a-F1b) and bottom sheets
(F24a-F24b) each together.
2.
Glue the longerons(F5a-F5b, F23a-F23b) together.
3.
Assemble plywood doubler(F2), longerons(F3a,F4a, F5a,
F5b) and bulkheads(F7-F9,F13-F14) on the right side sheet
(F1a, F1b) and then, glue with thin CA.
Note
Make sure to pay attention to all the bulkheads, the
part numbers should be facing forward.
4.
Assemble battrey tray(F21), steering servo tray(F22),
plywood doubler(F2), longerons(F3a,F4a, F5a, F5b) and
wing mount(F19,F20).
Note
Balsa mount(F20) must be located over the plywood
mount(F19).
5.
Assemble bulkheads(F15-F18) and longerones (F6).
6.
Assemble left side sheet(F1a, F1b).
Apply thick CA glue at each joints for reinforcing
.
7.
Glue frames(F25a) and top sheet(F26a) with
thick CA
.
8.
Assemble and glue longerones(F23a,F23b) with
thick
CA
.
Page 5
