Temporary Safety Jumpers & Dip Switch Settings
E-S 1000D Series Instruction Manual
3.8
If you are not using a safety
device like a photo eye or safety
loop the Photocell terminal must
remain jumped to the GND
terminal.
!
IMPORTANT:
We recommend before turning the gate
opener on for the first time to have dip switch 1 OFF. If
the dip switch is set to on, the gate will autoreclose
after turning it on without any intentional activation on
your part.
ON:
Auto-Close on (the gate will
re-close from the open position after a
time set in the programming section)
OFF:
Auto-Close off
ON:
Dual gate opener (2 motors)
OFF:
Single gate opener (1 motor)
ON:
Gate lock terminals active
OFF:
Gate lock terminals inactive
1.
2.
3.
Dip SwitchesTo change any dip switches, you must turn the
power off before changing the setting.
Photo jumped to GND
Summary of Contents for E-S 1000D Series
