E-S 500 / 502 Classic Series Instruction Manual
Installation of Operator — Push-to-Open
2.10
1) Locate the set back template found in the
box to determine the proper setback. Create
a template out of the boomerang bracket by
tracing it on a piece of cardboard.
2) Find the proper setback for your operator
(from previous page). Hold the lower “L”
shaped bracket along with the boomerang
bracket template against the post near the
hinge. [
See Fig. 1
]
Mark how much of the boomerang bracket
you will trim off on the template.
The hole on
the end of the boomerang bracket should be
in the setback position.
NOTE:
The “L” shape brackets in our illustrations
are on the rear side of the post. The “L” shape
brackets in your situation may be on the same
face of the post as your hinges, this will be de-
termined by the relation of the setback to the
hinge location of your gate.
3) Trim boomerang bracket template, then
double check setback positioning.
Using the template, mark the boomerang
bracket for cutting. [
See Fig. 2
]
4) Cut off the excess length (if any) of the
boomerang bracket using a sawzall or hack-
saw.
Fig 2
Fig 1
Alternate Mounting Option
Summary of Contents for E-S 500
