Estate Swing E-SC 1600 / E-SC 1602 Column Mounted Gate Opener Instructions.
Accessory Wiring
25
The manufacturer instructions that come with your accessory should have markings for wires or terminals
to connect to the gate opener. Please look for terminals named below in the instructions for the accessory.
Keypads, Receivers:
Normally Open (NO) or Input (INP) or Relay of entry device
= COM ter minal (to right of PUSH1) of
PUSH block on gate opener control board.
Common (COM) or Ground (GND) or Relay of entry device
= PUSH1 ter minal of PUSH block on gate
opener control board.
NOTE:
If the power for the accessory shares a Ground wire/ter minal with the relay –
Do Not power that
accessory off this control board (example: WKP-P keypad). Instead power that device with batteries.
24V Power positive (+) or (24V) or (PWR) of entry device
= +24V ter minal of PHOTO block on gate opener
control board.
24V Power Negative (-) or (GND) or (PWR) of entry device
= GND ter minal of PHOTO block on gate
opener control board.
Push Button, Intercoms:
Normally Open (NO) or Input (INP) or Relay of entry device
= COM ter minal (to right of PUSH1) of
PUSH block on gate opener control board.
Common (COM) or Ground (GND) or Relay of entry device
= PUSH1 ter minal of PUSH block on gate
opener control board.
Push buttons do not require power and Intercoms draw too much power to power from the gate opener.
Exit Wand/Sensor, Exit Loop Detector, Exit Device:
Normally Open (NO) or Input (INP) or Relay of exit device
= COM ter minal (to right of PUSH2) of PUSH
block on gate opener control board.
Common (COM) or Ground (GND) or Relay of exit device
= PUSH2 ter minal of PUSH block on gate open-
er control board.
24V Power positive (+) or (24V) or (PWR) of exit device
= +24V ter minal of PHOTO block on gate opener
control board.
24V Power Negative (-) or (GND) or (PWR) or Shield wire of exit device
= GND ter minal of PHOTO block
on gate opener control board.
