4
8. Keep air inlets and exhaust ports free from obstructions. Blocked air inlets or
exhaust ports can cause the unit to overheat.
9. Do not use solution or recovery tanks for storing hoses, cords or accessories.
10. When using electrical equipment around water it is important to wear rubber
soled shoes and keep machine properly grounded at all times. Failure to do so
could result in a fatal electric shock.
OPERATING INSTRUCTIONS
1. Insert electrical cords into 3 pin grounded outlets. Two cord machines that are
equipped with an
Optional
Circuit Indicator located above the Switch Plate. The
electrical cords must be plugged into separate circuits. When this is achieved the
green light will illuminate showing the machine is ready for operation.
2. We recommend the use of a Esteam liquid Defoamer, to prevent the machine
from prematurely shutting off due to excess foam in the recovery tank. Turn on
vacuum and pour approximately ¼ cup of Esteam Liquid Defoamer into the end
of the vacuum hose.
3. 200 PSI pump priming instructions:
Using Primer Quick Connect
- Fill fresh water tank
- Attach vacuum and solution hose to machine
- Attach primer quick connect to end of solution hose
- Place solution hose with primer quick connect into open end of vacuum hose
and hold
- turn vacuum and pump switches on
- Once a continuous flow of water is entering the vacuum hose, this indicates
pump is primed
- Turn off vacuum and pump switches and disconnect primer quick connect
- Connect solution hose and vacuum hose to carpet wand
- Turn vacuum and pump switches on
- Machine is ready to use.
TO USE YOUR NINJA HEATER:
A. Hook the wand solution hose to the quick connect of your machine.
B. Plug the heater power cord into a wall that is on a separate circuit form the other
cord.
C. Turn the heater switch on.
D. When the red light goes out, solution is heated and ready to use.
Summary of Contents for NJA150
