5
OPERATING INSTRUCTIONS (CONTINUED)
WARNING:
If your heater does not work DO NOT attempt to repair it yourself, call your
distributor for repair procedures. Using solvents in heaters can be hazardous and will
void your warranty. Allowing heaters to freeze will crack the heater cartridge and will
also void your warranty.
DANGER:
No solvents of any type may be used in this system at any time. The use of
solvents is extremely hazardous resulting in possible fire and/or explosion.
4. Connect vacuum and solution hoses to the carpet cleaning wand.
5. Proceed to clean carpets.
6. When the recovery tank becomes full, vacuum will automatically stop extracting.
When vacuum stops extracting it will make a distinctive high pitched noise as all
the air flow will be cut off. At this time switch unit off. Drain the recovery tank by
pulling up on drain valve on front of machine.
NOTE:
Ensure that the high water level float screen inside the recovery tank is free
from any obstructions. Be sure to close drain valve before resuming cleaning.
7. To empty solution tank remove vacuum hose from wand. Turn on vacuum and
extract solution from solution tank into recovery tank, then drain recovery tank.
NOTE:
Do not completely submerge end of vacuum hose into solution. Allow some air
to enter end of vacuum hose with liquid.
8. When the job is completed empty and rinse out the solution and recovery tanks.
Allow vacuum to run for 3 to 5 minutes. This will eliminate all moisture from
vacuum assuring long vacuum life.
WARNING:
When using electrical equipment around water it is important to wear
rubber soled shoes and keep machine properly grounded at all times. Failure to do so
could result in electric shock.
Summary of Contents for NJA150
