8
PROBLEM
CAUSE
SOLUTION
6. Vacuum operates but has
poor or no suction
1. Recovery tank full
1. Drain recovery tank
2 Vacuum hose plugged
2. Locate and remove
blockage
3. Wand plugged
3. Locate and remove
blockage
4. Exhaust port blocked
4. Locate and remove
blockage
5. High level float stuck in
off position
5. Turn vacuum off and tap
top of float screen cage
6. Front drain valve left
open after draining
recovery tank
6. Close recovery tank
drain valve on front of
machine
7. Vacuum prematurely
stops extracting
1. Excess foam in recovery
tank
1. Add defoamer to
recovery tank
2. Lint or dirt on automatic
shut off float screen
2. Clean auto shut off float
screen
3. Defective float ball
3. Replace float screen
cage
8. Machine spits water out
of exhaust port
1. High level float not
working properly
1. Check auto shut off float
cage and ball for proper
operation
9. Machine blowing
excessive amounts of water
out of exhaust ports
1. Damaged (leaking)
recovery tank fittings
1. Immediately shut unit
down. Bring unit to a dealer
for service
10. Water accumulating in
bottom electrical
component area
1. Inside solution line
leaking
1. Immediately shut unit
down. Bring unit to a dealer
for service
2. Pump leaking
2. Immediately shut unit
down. Bring unit to a
dealer for service
3. Solution or recovery tank
leaking from above
3. Immediately shut unit
down. Bring to a dealer for
service
11. Heater won’t work
1. Heater cord not plugged
in
1. Connect cord to 3 Pin
(separate) outlet
2. Faulty Thermostat or
Thermo cut-out
2. See dealer
12. Water not hot enough
1. Check Jet size on wand
or upholstery tool
1. Do not exceed .03 orifice
size for maximum heat
transfer
2. Cold water used in
solution tank
2. Use hot tap water for
maximum heat transfer
Summary of Contents for NJA150
