HOW TO FLY
CORRECTING DRIFT
LINK THE TRANSMITTER
LANDING SAFELY
TROUBLESHOOTING
REPLACEMENT BLADES
LED
It is normal for the Proto X to drift slightly. However if it drifts in any
direction consistently press the trim button opposite the movement
as many times a needed to eliminate the drift.
UP
FORWARD
FORWARD
DOWN
ROTATE LEFT
ROTATE LEFT
LEFT
LEFT
LEFT TRIM
FORWARD TRIM
FORWARD TRIM
LEFT TRIM
ROTATE RIGHT
ROTATE RIGHT
RIGHT
RIGHT
RIGHT TRIM
FRONT
Gray Blades, Blue LEDs
REAR
Black Blades, Red LEDs
BACKWARD TRIM
BACKWARD TRIM
RIGHT TRIM
BACKWARD
BACKWARD
DOWN
UP
Hold the throttle stick at full down and turn on the controller.
Wait until the red LED turns green.
When the battery voltage begins to run low, the LEDs will begin
to fl ash. It is time to land before the built in low voltage cut off
reduces power to the motors.
PROBLEM:
Controller cannot be linked to the ProtoX.
SOLUTION:
Throttle position needs to be at zero.
PROBLEM:
Controller LED fl ashing after binding.
SOLUTION:
Replace batteries.
PROBLEM:
Proto X shaking.
SOLUTION:
Check if the canopy, chassis and rotors are damaged.
PROBLEM:
Will not take off.
SOLUTION:
Check that the rotor blades are properly installed.
4606 © 2013 Estes-Cox Corp. A subsidiary of Hobbico, Inc.
