FRA
FRA
DR
AFT
DR
AFT
ENG
ENG
B) Light Therapy Mode
LedSonic
®
uses a super-luminous LED array to deliver concentrated beams
of light for fractional phototherapy effect. This safe, painless, natural healing
process converts light energy within skin cells, very similar to the way
photosynethesis takes sunlight and turns it into food energy in plants. To
maximize the effect, we highly recommend you:
• For acne treatment: Use the blue LEDs light therapy for 3 minutes over
affected areas twice daily. To maximize the results, follow with the red
LEDs light therapy use for 3 minutes over affected areas twice daily.
• Skin rejuvenation and firming: Use the red LEDs light therapy, holding the
appliance for 3 minute on difference of each area of the face (see section
4.2.2 “Areas not to treat”), then move to another area of the face.
The appliance will sound “B” to remind you in every minute.
• Use it for 3 times a week.
• If the area that require more rejuvenation, it is suggested to use for 3
minutes over there.
7. Cleaning, maintenance and storage
7.1
Cleaning
CAUTION: Before cleaning your LedSonic
®
, make sure that the power
switch is OFF and the power cord is disconnected from the charger base.
• Never clean LedSonic
®
or any of its parts under the tap or in the
dishwasher.
• Never use abrasive cleaning agents or aggressive liquids such as petrol
or acetone to clean the appliance.
• Use the soft cloth included with your LedSonic
®
appliance to clean the
following parts:
Fig. 11
• Maximize the effects of your skin care products –
ultrasonic wave is effective for the ingredients penetration,
and specific frequencies for difference area:
A) Using with products like essence serum, lotion:
Repeat each step a total of 5 times glide LedSonic
®
very slowly and slightly. (See Fig. 11)
B) Using with products like facial mask: Repeat each
step a total of 10 times glide LedSonic
®
very slowly
and slightly. (See Fig. 11)
5 MHz
1 MHz
• The surfaces of the main body and charger base
• The surfaces of the attachments
7.2
Maintenance and storage
• Store LedSonic
®
in a dry place at a temperature between 0°C and 60°C
• If you want to replace a part or want to purchase an additional part, please go
to your local provider or contact us at
www.esthermichele.com
7.3
To protect the environment
• At the end of its life,
do not
discard LedSonic
®
with the normal
household waste. Dispose of it at an official recycling collection
point.
8. Troubleshooting
Refer to this troubleshooting guide if you experience any problems with
LedSonic
®
, as this section addresses the most common problems you could
encounter with this appliance. If you still have problems, please contact go
to your local provider or contact us at
www.esthermichele.com
Solution
Charge the appliance (see
section 5.1 “Charging”
Contact the nearest EM dealer
Use a dry finger to touch on the
key for few seconds.
Charge the appliance
No action is required
Insert the PLUG into the
CHARGER BASE SOCKET.
Connect another wall socket
to check if the electrical outlet
is live
If it is still does not charge,
contact your nearest EM dealer
Possible reason
The rechargeable batteries
are empty
The appliance is defective
Improperly touch the
“ON / OFF” key
The rechargeable batteries
are empty
This is normal
The POWER ADAPTOR is
not plugged in the electrical
outlet
Problem
LedSonic
®
does not work
LedSonic
®
suddenly
switches off
The appliance temperature
rises during operation and
recharge
Battery charging indicator
light (“SELECT” key blue
light) does not turn on
when connecting the PLUG
into the CHARGER BASE
SOCKET
