ProNet series AC servo system User’s manual V.1.08
- 16 -
2.1.3 Installation Alignment
Align the shaft of the servomotor with that of the machinery to be controlled, and then connect the
shafts with elastic couplings.Install the servomotor so that alignment accurancy falls within the
range shown below.
Measure this distance at four different positions in the circumference. The difference between the
maximum and minimum measurements must be 0.03mm or less.(Turn together with couplings.)
2.1.4 Installation Orientation
Servomotor can be installed ethier horizontally or vertically.
2.1.5 Handling Oil and Water
If the servomotor is used in a location that is subject to water or oil drops, make sure of the
servomotor protective specification. If the servomotor is required to meet the protective
specification to the through shaft section by default, use a servomotor with an oil seal.
Through
Through
Through
Through shaft
shaft
shaft
shaft section:
section:
section:
section:
It refers to the gap where the shaft protrudes from the end of the servomotor.
Note:
Note:
Note:
Note:
·If the alignment accurancy is incorrect , vibration will occur, resulting in damage to the bearings.
·Mechanical shock to the shaft end is forbidden, otherwise it may result in damage to the encoder of the servomotor.
Through Shaft Section
