Chapter 2
Installation
- 17 -
2.1.6 Cable Tension
When connecting the cables, the bending radius should not be too small, do not bend or apply
tension to cables.
Since the conductor of a signal cable is very thin (0.2 to 0.3 mm), handle it with adequate care.
2.2 Servodrive
ProNet series servodrive is a base-mounted type. Incorrect installation will cause problems. Always
observe the installation instructions described below.
2.2.1 Storage
When the servodrive is not used, store it in the temperature between -20
℃
and 85
℃
with the
power cable disconnected.
2.2.2 Installation Sites
Notes on installation are shown below.
Situation
Situation
Situation
Situation
Notes
Notes
Notes
Notes on
on
on
on installation
installation
installation
installation
When installed in a control
panel
Design the control panel size , unit layout, and cooling method so that the temperature
around the periphery of the servodrive does not exceed 55
℃
.
When installed near a
heating unit
Suppress radiation heat from the heating unit and a temperature rise caused by
convection so that the temperature around the periphery of the servodrive does not
exceed 55
℃
.
When installed near a
source of vibration
Install a vibration isolator underneath the servodrive to prevent it from receving vibration.
When installed in a location
subject to corrosive gases
Take appropriate action to prevent corrosive gases. Corrosive gases do not immediately
affect the servodrive, but will eventually cause contactor-related devices to malfunction.
Others
Avoid installation in a hot and humid site or where excessive dust or iron powder is
present in the air.
