F1000 User's Manual
3
Chapter 2 Installation
2.1 Installation guide
2.1.1 Installation position
Please keep distance between the product and the interface of electric equipment, such as
AC power cord, the PLC output module, contactor, starter, relay, and so on.
Please especially caution that keep distance with the variable frequency speed governor and
switching power supply. Because this kind of devices’ input and output cable must be shielded
cable, and the shielding net access to system’s star ground.
2.1.2 NEMA4 standard installation
Cabinet details
F1000 series product can be installed at a depth of more than 105 mm, we recommend you
install the product at the front panel of the cabinet. To ensure that normally open the front panel
of the cabinet, please keep at least 25 mm distance around the installation products.
NEMA-4 installation
Puts the product into the mounting holes, and then respectively screw the 4 screws into the
screw fixing hole from the back of panel, then tighten the screws one by one, till the product is
firmly fixed on the panel.
[Caution]
Do not be too hard to screw the screws!
Installation standard
To ensure compliance with the seal specification of NEMA4, all mounting screws is provides
with the product must be used, and the installation panel bending cannot be over 0.010
°.
2.1.3 Environment precautions
Because the built-in LCD display panel, F1000 series product are restricted to indoor
use. Please ensure that the product is installed correctly, and the environment is in
accordance with the constraints of hardware specification (for details, please refer to the
hardware specification)
.
Do not use in hazardous situations, such the flammable gas, the steam, the dust.
Do not use in great changes of temperature or humidity, it may lead to internal device
condensed water, resulting in damage to the device.
www.zetek.ru
