3 Utilization
Turning the knob to the right will increase the temperature in the room by 3,5 °C in the highest
point. Turning the knob to the left will lower the temperature, maximum by 3,5 °C. If the knob is not in
neutral position, then the values of temperature measured – shown on the controller, will be different
than the real ones. This is the correct operation of controller.
4 Non-standard configuration
4.1 Switches
The transmitter and receiver are pre-configured in the factory to the operation with controllers
IGNEO Wall (Platinum bio) and IGNEO Compact. Four switches placed inside the transmitter and receiver,
which are designated with number from 1 to 4, change standard settings – for example, to increase the
number of CTP-02R sets, or to change transmission or indications of controller.
4.1.1 Addressing
Addresses are determiend by the combination of the settings of three first switches in the
transmitter and receiver. Addressing makes a parrallel operation possible of up to 8 sets of transmitter-
receiver in the same residential building. The same address in the transmitter and receiver should be set
up to have the correct communication. Below you will find the xample of addressing and the table with all
addresses:
page 12
PL20130612
