26
The LokPilot XL V3.0 is capable of handling both the short and
the long mode. LokPilot V3.0 decoders starting with software
version 0.0.6560 support the long mode. The LokPilot micro V3.0
as well as the the LokPilot Fx V3.0 and the LokPilot Fx micro V3.0
can only handle the short mode.
8.2.3.1. Changing the Programming Mode
Enter the programming mode with the 6020/6021:
The throttle must be set to „0“8.2.3.1. No other locomotives
may be on on the layout. Watch out for flashing signals of the
locomotive!
•Press the „Stop“ and „Go“ buttons of the 6021 simultaneously
until a reset has been triggered (alternately pull the mains plug
of the transformer). Press the „Stop“ button in order to switch
off the track voltage. Enter the current decoder address. If you
do not know the current address, simply enter „80“.
•Activate the change-of-direction button (turn the throttle knob
to the left beyond the arrestor until you hear a click sound), hold
it in this position and then press the „Go“ button.
Please bear in mind that the 6020/6021 only permits you to enter
values from 1 to 80. The value 0 is missing. Always enter „80“
instead of „0“.
8.2.3.2. The Short Mode
The decoder is in the short mode (the headlights flash periodically
in brief intervals).
•Now enter the number of the CV that you want to adjust e.g.:
„01“. Always enter this number with two digits.
•For confirmation activate the change-of-direction routine (now
the lights flash twice very quickly).
•Now enter the new value for the desired CV, e.g.: 15 (two digits).
•For confirmation activate the change-of-direction routine (now
the lights light up for about one second).
•Then you can enter other CVs as desired.
•Selecting „80“ allows you to exit the programming mode.
Alternately you can switch off the track voltage and then on
again (press the „Stop“ button on the 6021, then the „Go“
button).
8.2.3.3. Long mode
You access the long mode by entering the value 07 in CV 07
while in the short mode. The decoder confirms the change to
the long mode by slowly flashing lights.
•Enter the hundred-digit and the ten-digit (decade) of the CV
that you want to change. Example: If you want to adjust CV
124, you enter „12“.
•For confirmation activate the change-of-direction routine (now
the lights flash periodically: long – short – long – short - etc.)
•Now enter the unit of the CV („4“ in this example).
•For confirmation activate the change-of-direction routine. Now
the decoder expects the entry of the CV value. The lights flash
periodically: long – short – short).
•Now enter the hundred-digit and the ten-digit (decade) of the
new CV value (as a two-digit number). Example: You want to
write the value 135. Therefore, you enter „13“.
•For confirmation activate the change-of-direction routine. Now
the lights flash periodically: long – short – short – short).
•Now enter the unit of the new CV value as a two-digit number
(„05“ in this example).
•For confirmation activate the change-of-direction routine (now
the lights light up for about one second).
•Now you can adjust more CVs in long mode.
•Exit the long mode by switching off the track voltage and then
on again (press the „Stop“ button on the 6021, then the „Go“
button).
Programming
Summary of Contents for LokPilot Fx micro V3.0
Page 69: ...69 For your personal notes ...
