5
Copyright 1998 - 2009 by ESU electronic solutions ulm GmbH & Co KG. Electrical
characteristics and dimensions are subject to change without prior notice. All rights reserved.
ESU might not be held responsible for any damage or consequential loss or damage
chaused by inappropriate use of the product, abnormal operating conditions, unauthorized
modifications to the products etc...Not suitable for children under 14 years of age.
Inappropriate use may result in injury due to sharp points and edges. Märklin® is a
registered trademark of the company Gebr.Märklin® and Cie. GmbH, Göppingen,
Germany. RailCom is a registered trademark of the company Lenz Elektronik GmbH,
Giessen, Germany.
All the other trade marks are owned by their respective right holders.
ESU electronic solutions ulm GmbH & Co. KG continues to develop the products according
to the company´s politics. Therefore, ESU reserves the right to carry out changes and
improvements on the products listed in this manual at any time and without any advanced
note.
Duplications and reproductions of this documentation are strictly forbidden and need to
be allowed by ESU in writing.
3. Important Notes – Please read this chapter first
We congratulate you to your purchase of an ESU LokPilot decoder.
This manual will guide you step by step through the features of
your LokPilot decoder.
Please read this manual carefully. Although the LokPilot has been
design as a robust device an incorrect connection may lead to
faults or even to the destruction of the device. Avoid any “costly”
experiments.
Important notes
•The LokPilot is exclusively intended for use with model train
layouts only. It may only be operated with the components listed
here. Any other use is not permitted.
•Any wiring has to be carried out while power is disconnected.
Please make sure that no voltage reaches the locomotive while
converting it, above all not accidently.
•Avoid mechanical force or pressure on the decoder.
•Do not remove the heat shrink sleeve on the decoder.
•Make sure that neither the LokPilot decoder nor any blank wire
ends may come into contact with the engine chassis (risk of
short circuit). Cover any blank ends of unused wires.
•Never solder on the circuit board, extend cables if necessary
•Never wrap the decoder in insulation tape, since this may cause
overheating
•Adhere to the wiring principles as outlined in this manual for
wiring any external components. Other circuitry may cause
damage to the LokPilot .
•Make sure that no wires are squeezed or cut by the model’s
transmission parts when reassembling the engine
•Any power supply must be protected by a fuse or circuit breaker
to avoid any potential hazards such as burning cables in case of
a short circuit. Only use transformers specifically designed for
model trains that bear the VDE/EN marks.
•Never operate the LokPilot unattended. The LokPilot is not a
(children’s) toy.
•Do not expose to wet and humid conditions
Summary of Contents for LokPilot Fx micro V3.0
Page 69: ...69 For your personal notes ...
