18
Example 2:
3 aspect H/V exit signal
b)
a)
d
e)
a) The signal aspect „Hp0” is shown when the assigned turnout
number (here: 7) indicates the state „r” i.e.: „Diverging/Odd”.
b) The signal image „Hp1” is displayed when the assigned turn-
out number (here: 7) indicates the state „g” i.e.: „Green/
Straight”.
c) The signal image „Hp2” is displayed when the assigned turn-
out numbers (here: 7 and 8) indicate the state (g) i.e.: „Green/
Straight”.
d) The figures „#1” or „#2” indicate that this signal uses the first
two out of a total of 16 turnout numbers of the SignalPilot.
The turnout numbers used for signals are internally referred to
as „SAN” (“Signal Address Number”).
e) The currently assigned turnout numbers (here: 7 and 8) are
displayed in square brackets after the signal name.
c)
If you hover the mouse on one of the signal images, you will see
which lights will be on:
To switch the two signal aspects, the „red” or „green” buttons of
the corresponding turnout number must now be pressed at the
turnout console:
keyboard
9 10 11 12 13 14 15 16
HP0
switch 7 red
HP1
switch 7 green
HP2
switch 8 green
1 2 3 4 5 6 7 8
Turnout numbers and signal aspects
