25
LOUDSPEAKER WIRING & CONNECTION
2-Channel Amplifier VE1000.2 / VE1800.2
CONNECTIONS
• Connect the head unit line outputs (REAR L & R or SUBWOOFER L & R) with the RCA LINE INPUTs of the
amplfier with appropriate RCA cables.
• Connect the Subwoofer with SPEAKER LCH and RCH - of the amplifier by using appropriate cabels.
• The final speaker impedance should not be lower than 2 Ohms per channel. Too low speaker loads
result in too high heat dissipation and may cause the amplifier run into protection mode.
CONFIGURATION
•
Set T10 to BANDPASS / LOWPASS. The upper threshold frequency should be between 60Hz and 150Hz
depending on subwoofer size and it is adjustable by T11. In this mode T7 (lower frequencies) and T11 (upper
frequencies can be used as SUBSONIC FILTER (See page 32).
• When the pushbuttons T5 & T9 are pressed the slew rate of frequency response is raised up to 24 dB.
• When PHASE SHIFT is activated by T3 (MONO) the acoustical center is adjustable by T1 (See page 32.)
BASS BOOST & BASS REMOTE
• T8 allows you to adjust the BASS BOOST between 0 and 18 dB. Please use the BASS BOOST carefully.
The included BASS REMOTE allows you to adjust BASS LEVEL from the driver's seat.
INPUT GAIN
• Turn the INPUT GAIN - control (T6) on the amplifier to 9V-Position.
• Turn the head unit volume control to about 80-90% of its full setting.
• Turn the INPUT GAIN - control (T6) clockwise until you hear some distortion.
• Then turn back the INPUT GAIN - control (T6) slightly until you can hear clean sound.
1-CHANNEL-MODE: 1 Subwoofer / Mono bridged
4 OHMS
SUBWOOFER
RADIO / HEAD UNIT
BALANCED INPUT
This Input can optionally be used with
appropriate cables and symmetrical
signal transmitters. Please do not use
this Input at the same time as the
RCA Inputs.
LINE OUTPUT
Optional triggering to
use additional amplifiers.
The different modes
can be selected with
the T12-Switch.
Caution!
Be careful not to connect speaker (-) to the ground or vehicle chassis.
Please observe speaker channel and polarity as printed by the speaker terminal block.
Incorrect phasing of the speakers results in total loss of bass response.
BASS REMOTE
MIN - MAX Level Controller
White LED = Operation Mode
Red LED = Protection Mode
MIN MAX
LEVEL
