– 9 –
ETAsys.com
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800-321-6699 • Fax: 800-996-3821
ETA-PD8A
AC Power Conditioner & Distribution Unit
INSTALLATION
Before installing, read the entire manual to ensure proper understanding of operation and that all features are being utilized. The
ETA-PD8A can be placed on a shelf or rack mounted in a standard 19" width rack. When rack mounted, placement within the rack is
flexible, however the ETA-PD8A should be within 6' of a dedicated 15A AC outlet. When rack mounting, use rack rail type screws of
10
⁄
32
" x 1". Always make sure the 15A outlet is properly inspected by a certified electrician prior to connecting the ETA-PD8A. Make sure
to inspect the equipment that will be connected to the ETA-PD8A to ensure it does not exceed 15A total amperage draw.
AC POWER CORD RETAINER SYSTEM
Connect the IEC 14 Gauge 12' (4m) power cord to a 15A 120VAC outlet to provide power to the ETA-PD8A by aligning the pins of the
cord to the pins on the chassis and inserting the cord. Press firmly to assure a good connection.
The ETA-PD8A incorporates an IEC Power Cord retainer bracket to prevent the cord from coming loose. To install the IEC power cord
retainer bracket, remove the two screws from the chassis of the ETA-PD8A, place the retainer bracket over the cord and insert the two
screws through the bracket into the chassis as illustrated below.
