eta 0311, Instructions For Use Manual

16

GB

-

When the appliance is overheated, the automatic heat fuse is activated and it disconne

-

cts power supply. If it happens, switch off the appliance and unplug it from the socket. 

Remove possible visible obstacles preventing air flow and let the appliance cool down.

-

Disconnect the appliance from power supply right after use by unpluging the power cord 

from the socket and let it cool down before storage.

-

Make sure that the power cord does not hang over the edge of the working table where 

children could reach it.

-

Do not wind the power cord around the appliance, this will extend life of the power cord.

-

If you need to use the extension cord, it has to be incorrupted and it has to comply with 

the valid standards.

-

The power cord must not be damaged with sharp or hot objects, open fire, it must not 

be sunk into water or bent over sharp edges.

-

If the power cord of the appliance is corrupted, it has to be replaced by the producer, its 

service technician or a similarly qualified person so as to prevent dangerous situations.

-

Never use the appliance for any other purpose than for the intended purpose described 

in these instructions for use!

-

The producer does not guarantee any loss caused by improper handling of the appli

-

ance and its accessories (e. g. 

electrical accident, fire, burn, hair damage

) and its 

guarantee for the appliance does not apply in the case of non-compliance with the 

safety instructions above.

II. FEATURES OF THE DEVICE 

(pic. 1)

A – drier

A1 – temperature and air flow intensity switch

position 0 – off 

positon 1 – medium temperature and air flow intensity

positon 2 – maximum temperature and air flow intensity

poloha   – decrease of the air flow temperature (quick cooling and fixation of hair  

   in the final stage of hairstyling)

A2 – voltage switch 230 V / 120 V

 (enables you to set the operational voltage 

for the current mains - use a screwdriver or a coin for setting)

A3 – handle 

A4 – removable grid

A5 – loop for hanging

A6 – supply cord

B – direction attachment

 (to point the air at a desired spot)

III. INSTRUCTIONS FOR USE

Remove all packaging material and remove the drier with accessories. Accessory pull on 

the direction attachment Connect the plug of the supply cord into an outlet.