eta 0638, User Manual

III. PREPARATION OF THE APPLIANCE 

Remove all packaging and take the appliance and all accessories out. Remove all 

adhesive foils, stickers or paper from the appliance and its accessories. Place the 

appliance on an even and dry surface (e.g. kitchen table), out of reach of children (see 

I.

SAFETYADVICE

). Prior to the first use, wash the parts that come in contact with food in 

warm water with soap and rinse them thoroughly with clean water, dry with a kitchen towel 

or air dry. The appliance is now ready to be used. 

InstallationandRemovaloftheCO

2

Carbonator

 (Fig. 2, 3, 4)

Place the appliance on the front or side for easier manipulation. Apply low force to remove 

the arrester on the bottom side of the appliance until it is released; then remove the back 

cover 

A4

. Remove the protective cap (seal) from the pressure bottle 

C

 (carbonator). 

Insert the carbonator into the opening and turn it around (clockwise) so that the valve gets 

screwed in the holder. Apply reasonable force (lightly) to tighten the carbonator. Insert the 

cover behind the top part of the appliance and fasten it with a click. Proceed in reverse 

order to remove the carbonator from the appliance. 

ATTENTION

 –  

Check that the carbonator valve is not damaged. 

 –  

Check that sealing is inserted in the holder and that it is not damaged or worn out. 

 –  

Do not use any tools to install the carbonator (e.g. keys, pliers). 

 –  

Do not apply excessive force to tighten the carbonator to prevent gas leak. 

!

InstallationandRemovalofthePETBottle

 (Fig. 5, 6, 9)

Release the arresting device of the hatch by pressing button 

A2

 and open the hatch 

A3

. 

You may remove the drip tray 

A6

 for easier manipulation. Unscrew the cap 

B1

. Slide the 

neck of the bottle 

B

 on the nozzle until it fits in the holder and then apply reasonable force 

to turn the bottle (anticlockwise) end to end (you will hear a click sound). Lightly pull the 

bottle to check that it is properly installed. Return the drip tray. Close the hatch. Proceed in 

reverse order to remove the bottle from the appliance.

ATTENTION

 –  

Check that the bottle is not visibly damaged. 

 –  

Check that sealing is inserted in the holder and that it is not damaged or worn out. 

 –  

Do not use any tools to install the bottle (e.g. pliers). 

!

IV. USE OF THE APPLIANCE (Fig. 2 - 13)

Place the appliance on a dry and even surface. Install the CO

2 

carbonator correctly 

(see instructions above). Fill up the PET bottle with drinking water up to the level 
marked with MAX. 

Attention:donotaddanysyrupconcentrates,

iceorcrushediceinthewater!

Youmightcausethenozzle

obstruction!

Install the PET bottle in the appliance correctly (see instructions above). 

Check that the end of the nozzle

is immersed in water. Close the hatch 

A3

. Press the 

button 

A1

 shortly and firmly (approx 2 sec) to release carbon dioxide. Press once or twice 

for standard carbonated water. The carbonation of water with CO

2

 is accompanying by a 

typical sound – “soft whistling”. This is completely normal and it is not a reason for sales 

return. Loud “whistling” signals that the water has been sufficiently carbonated and the 

excess of the gas is leaking. 

23

GB

/ 44