eta 0762, Instructions For Use Manual

–  Use the appliance in the working position only at places with no risk of turning over 

and in sufficient distance from heat sources (e.g. 

heater, stove, cooker, oven, grill

), 

flammable objects (e.g. 

curtains, drapes, etc.

) and wet surfaces (e.g. 

sinks, wash 

basins, etc.

).

POWER CORD:

–

If the power cord of the appliance is corrupted, it has to be 

replaced by the manufacturer, its service technician or a similarly 

qualified person so as to prevent dangerous situations.

–  Never put the power cord on hot surfaces and never let it hang over table edge or 

worktop edge. If the cord is caught or pulled, e.g. by children, the appliance may overturn 

and fall down, causing a serious injury!

–  The power cord must not be damaged with sharp or hot objects, open fire, it must not be 

sunk into water or bent over sharp edges.

–  If you need to use an extension cord for justified reasons, it must be undamaged and 

comply with the applicable standards.

–  Check the condition of the power cord of the appliance regularly.

–  In order to ensure safety and proper function of the appliance, use only original spare 

parts and accessories approved by the manufacturer.

–  Only use this appliance for the purpose it was designed for, as specified in this manual. 

Never use the appliance for any other purpose.

II. FEATURES

 (pic. 1)

A – case of the welder

A1 – indicator light 

A3 – air exhauster nozzle

A2 – welding wire  

A4 – power cord

B – foldable lid

C – PE foil roll
III. INSTRUCTIONS FOR USE

Remove all packaging, take out the appliance and connect the fork of the supply chord 

to a socket. The welder is supplied with a roll of PE foil. When welding the first bag, it is 

necessary to follow the following process:

– Fold back the 

B

 lid and unwind a sufficient amount of the foil 

C

 so that it exceeds the 

welder by 2 to 4 cm. 

Check if the welded spot is dry and clean

, fold the lid 

B

 back 

afterward. Make sure the foil is stretched straight without any creases on the welding 

wire 

A2

 before welding.

– Press on the lid 

B

 with both hands in order to make a perfect weld (pic. 2) and wait for 

the indicator light 

A1

 to turn off (approx. 10 sec). The indicator light signals the PE foil is 

being welded.

– Remove the rest of the foil by tearing before folding back the lid 

B

.

Air suction and bag welding

Fill the prepared bag to ¾ max. of its length (capacity) with food or anything you want to 

keep fresh. Place the open end of the bag on the welding wire 

A2

 so that the air suction 

nozzle 

A3

 is inside the bag‘s opening. Check for creases or folds in place of the future 

weld. The straighter this area is, the better. Fold the lid

 B

 on and push lightly on the right 

corner of the lid, which will trigger the air suction (you will hear the motor), hold the lid in 

this position but do not push it all the way down.

GB

15

/ 27