GB
11. The Eta 1349 is only intended to remove single hairs from the upper lip and chin. Hold
area taut and use a small brushing motion.
do not use like an electric shaver on your entire face!
12. Repeat within each area until all unwanted hair is removed. The time required to
remove unwanted hair depends on the user's hair type.
13. After each use Clean your Eta 1349, see Cleaning the Epilator.
14. Keep the protective cap on your unit when it is not in use.
15. The protective cap is designed to protect your unit from being turned on accidentally
so be sure to replace the protective cap after each use.
using the tweezers
1. Remove the tweezers from the epilator unit by pushing down the light up tweezers
release button towards the epilator bottom, and then pulling the tweezers out from the
epilator unit.
2. Turn the light on by pressing the raised button once. Press the button once again to
turn the light off.
note:
There is 7 minutes auto-off feature with the lighted tweezers.
3. Use the tweezers to shape eyebrows and remove single hair in sensitive areas.
4. After each use clean the Light Up Tweezers, see Cleaning the Tweezers.
Cleaning tHe ePilator
Regular cleaning and good maintenance ensures optimum results and will extend the
lifetime of your Eta 1349.
1. Before cleaning, make sure to turn off your unit.
2. Using the brush, enclosed, remove hair on all sides of the discs.
3. Put the protective cap on to safeguard the tweezers.
to remove residue:
To remove residue from the tweezers, use rubbing alcohol on the tip of the tweezers with
a cotton swab that has been squeezed dry.
note:
Make sure that the cotton swab is not soaked with alcohol.
Cleaning tHe tWeezers
1. Use the brush to remove hair from the tweezers.
2. Use rubbing alcohol on the tip of the tweezers with a cotton swab that has been
squeezed dry.
tWeezers battery rePlaCement
1. Unscrew the tweezers knob with logo and remove the battery.
2. Dispose of the used battery with care and property.
3. Replace new battery (3 pcs AC3/LR41 battery) into the light compartment with care.
4. Screw the tweezers knob until it is secured properly with the tweezer.
5. Ensure the raised button for the light feature is facing up when the tweezers knob is
screwed back to the tweezers.
