64/111
EN
Problem
Possible cause
Solution
The food is too warm.
Temperature is not properly
adjusted.
Please look in the initial
Temperature Setting section.
Door was open for an extended
period.
Open the door only as long as
necessary.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
Turn the temperature
regulation to a colder setting
temporarily.
The appliance is near a heat
source.
Please look in the installation
location section.
Appliance cools too
much
Temperature is set too cold.
Turn the temperature
regulation knob to a warmer
setting temporarily.
Unusual noises
Appliance is not level.
Re-adjust the feet.
The appliance is touching the
wall or other objects.
Move the appliance slightly.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
If necessary, carefully bend the
component out of the way.
Water on the floor
Water drain hole is blocked.
See the Cleaning section.
Side panel is hot
Condenser is inside the panel.
It’s normal.
If the malfunction shows again, contact the Service Center.
VII. TECHNICAL DATA
Technical information can be found on the type plate inside the appliance
(or on its back side) and on the energy label.
“Information Sheet” and “Directions for Use” can be downloaded at:
www.etasince1943.com.
QR code on the energy label supplied with the appliance provides a web link to information
concerning the specification of this appliance in the EU EPREL database.
Keep the energy label together with user manual and all other documentation supplied with
this appliance.
The same information in the EPREL database can also be found at:
https: //eprel.ec.europa.eu
The model name (product number) can be found on the type plate of the appliance and
also on the energy label supplied with the appliance.
We reserve the right to change technical specifications.
For any further information, please write to:
info@eta.cz
Summary of Contents for 254390000F
Page 112: ......
