III. PRePARATIoN oF THe APPlIANCe
Remove all packaging and take the appliance and all accessories out. Remove all
adhesive foils, stickers or paper from the appliance and its accessories. Place the
appliance on an even and dry surface (e.g. kitchen table), out of reach of children (see
I.
SAFETYADVICE
). Prior to the first use, wash the parts that come in contact with food in
warm water with soap and rinse them thoroughly with clean water, dry with a kitchen towel
or air dry. The appliance is now ready to be used.
InstallationandRemovaloftheCO
2
Carbonator
(Fig. 2, 3, 4, 5)
Place the appliance on the front or side for easier manipulation. Press the arresting button
A6
on the bottom side of the appliance and then remove the back cover
A4
. Remove the
protective cap (seal) from the pressure bottle
C
(carbonator). Insert the carbonator into
the opening and turn it around (clockwise) so that the valve gets screwed in the holder
A8
. Apply reasonable force (lightly) to tighten the carbonator. Insert the cover behind the
top part of the appliance and fasten it with a click. Proceed in reverse order to remove the
carbonator from the appliance.
ATTENTION
–
Check that the carbonator valve is not damaged.
–
Check that sealing is inserted in the holder and that it is not damaged or worn out.
–
Do not use any tools to install the carbonator (e.g. keys, pliers).
–
Do not apply excessive force to tighten the carbonator to prevent gas leak.
!
InstallationandRemovalofthePETBottle
(Fig. 7, 8, 11)
Unscrew the cap
B1
. For easier manipulation, push down the control
A2
and tilt out the
holder with the nozzle. Slide the neck of the bottle
B
on the nozzle
A3
until it fits in the
holder
A7
and then apply reasonable force to turn the bottle (clockwise) as far as it goes.
Pull the bottle lightly to check that it is properly attached. Then release the inclination
control. Proceed in reverse order to remove the bottle from the appliance.
ATTENTION
–
Check that the bottle is not visibly damaged.
–
Do not use any tools to install the bottle (e.g. pliers).
!
Iv. use oF THe APPlIANCe
(Fig. 2 - 12)
Place the appliance on a dry and even surface. Install the CO
2
carbonator correctly (see
instructions above). Fill up the PET bottle with chilled, clean drinking water up to the level
marked with guideline.
Attention:Donotaddanysyrupconcentrate,iceorcrushedice
inthewater!Youmightcausethenozzleobstruction!
Install the PET bottle to the appliance correctly (see instructions above). Check that the
end of the nozzle
A3
is immersed in water. Press the button
PusH
A1
shortly and firmly
(for max. 2 seconds) to apply carbon dioxide.
Thenslowlyreleasethebutton.
24
GB
/ 45
Summary of Contents for 4638
Page 3: ...3 MAX 2sec 3x P s s s 1 1 15 100 ml 1 9 40 ml 1 23 100 ml 1 9 40 ml 1 23 45...
Page 50: ......
Page 51: ......
Page 52: ...e 02 2016 DATE 3 3 2016...
