Problem
Cause
Solution
There is water
under the soda
maker
The amount of water in the
bottle exceeds the guide line
level
Only fill up the bottle with water up to
the guideline level
The button
A1
was pressed
for too long, too fast or
several times
Press the button shortly, wait for 5 – 10
seconds between presses and do not
press more than 3 times
Button
A1
has been
released too fast
The button must always be released
slowly
vI. MAINTeNANCe
(Fig. 16)
Do not use abrasive and aggressive cleaning agents (e.g.
sharpobjects,alcohol,
chemicalsolvents,diluents,ammoniac,causticagents
etc.). Wipe off the interior and
exterior and with a damp cloth after each use. Wash all accessories (PET bottle and cap)
in warm water (max 40 °C) with soap (or suitable disinfecting agent) immediately after use
and rinse with pure drinking water. Do not install the cap on the bottle if you are not going
to make another drink right away. Store the bottle and the cap separately so that they
can dry well. Some food can colour the accessories in some way. However, this does not
affect the function of the appliance and it is not a reason for a claim. This colouring usually
disappears after some time. Never dry plastic mouldings over a heat source (e.g.
heater,
electric/gasstove
).
GasketReplacement
By means of a suitable tool (e.g. a narrow screwdriver, needle), remove the gasket from
the holder
A8
. Put the new, spare gasket
A9
back so that it fits in the groove in the holder
along the entire perimeter.
Storage
Store the appliance on a dry place, out of reach of children and persons sui juris.
ATTENTION
–
Make sure that the contact areas and sealing elements are clean and functional.
–
The drainage outlets
A5
must be passable; do not adjust it in any way (e.g. by capping).
!
vII. eNvIRoNMeNT
If the size of the appliance allows, all the parts contain marking of the materials used for
production packaging, components and accessories as well as for recycling. The symbols
on the product or in the accompanying documentation mean that the product used must
not be liquidated together with communal waste. To ensure the appropriate liquidation take
the used appliance to a collection point where it will be accepted free of charge. Correct
liquidation of the product helps to protect valuable natural resources and helps to prevent
a potential negative impact on the environment and human health which can be the
outcome of inappropriate liquidation of waste.
GB
27 / 45
Summary of Contents for 4638
Page 3: ...3 MAX 2sec 3x P s s s 1 1 15 100 ml 1 9 40 ml 1 23 100 ml 1 9 40 ml 1 23 45...
Page 50: ......
Page 51: ......
Page 52: ...e 02 2016 DATE 3 3 2016...