Install the assembled meat mincer on to the multi-function head
A7
according
to the procedure in point 1. Now the meat mincer is ready for filling smoked goods.
To disassemble proceed in the reverse sequence. To disassemble the entire meat
mincer press the release button
A5
, turn the meat mincer clockwise and pull it out of the
multi-function head mount.
Appl
ication
Place the minced meat into the meat mincer‘s filling funnel
D11
. Use pusher
D10
to gently
push meat into the meat mincer
D
. Allow the casing to soak in warm water (approx. 10
min) so that its elasticity is improved and then slide it on to the output opening like an
„accordion“.
Leave 5 cm at the end of the casing free and tie or skewer it. Insert the power cord plug
A8
into a power socket. Put the appliance into operation by turning the speed dial
A2
to one of
the speed levels appropriate for preparing your ingredients.
Place the prepared mix into the filling opening and gently push in using the pusher
D10
.
When filling proceed according to the selected type of smoked good (e.g. white pudding,
sausage, cabanossi, etc.). After finishing processing, turn off the meat mincer by turning
the dial
A2
to position
0FF
.
Recommendation
We recommend that filling is done by two people at once, i.e. one inserts the mix and the
other holds the casing at the opening. Fill the casing so that air does not get inside. The
processing takes several minutes and depends on the amount of meat used. If the output
opening of the tube
D7
becomes clogged, it is necessary to turn off the drive unit and to
,disassemble the tube and to clean it.
3. Preparing pasta - tubes
Assembly
(pic. 5c)
Insert the conveyor screw
D1
into the meat mincer
D
with the cog wheel first. Attach the
mould
D8
to the conveyor screw so that the mould slot fits into the mount of the meat
mincer
D
. Push the cone
D9
to the mould and secure it in position by screwing the nut
D5
on to the meat mincer
D
. Tighten the nut with reasonable force. Install the assembled meat
mincer on to the multi-function head according to the procedure in point 1.
Now the meat mincer is ready to prepare pasta. To disassemble proceed in the reverse
sequence. To disassemble the entire meat mincer press the release button
A5
, turn the
meat mincer clockwise and pull it out of the multi-function head mount.
Application
Place the prepared dough into the meat mincer‘s filling funnel
D11
. If necessary use the
pusher
D10
to push the dough into the meat mincer
D
. The appliance will press out hollow
tubes, which you will cut down to the desired length.
Insert the power cord plug
A8
into a power socket. Put the appliance into operation
by turning the speed dial
A2
to one of the speed levels appropriate for preparing your
ingredients. After finishing processing, turn off the meat mincer by turning the dial
A2
to position
0FF
.
29
GB
/ 50
Summary of Contents for GRATUSSINO
Page 2: ...A3 A4 A5 A6 A7 A1 A2 A8 A 1 B3 B2 B1 2 50...
Page 3: ...4 3 D13 D14 3 50...
Page 4: ...5a 5b 5c 6 7 5d 4 50...
Page 5: ...8 9 5 50...