20
www.eta.co.at
Start-up
Close fuel chamber door, open ignition door
Close the fuel chamber door and then open the ignition
door.
If the boiler will not be started up yet, close both
doors and, in the boiler overview, switch off the
boiler using the
switch.
Ignite fire with cardboard and newspaper
Place crumpled paper or a few pieces of cardboard in
front of the first layer of wood and ignite it. The draught
fan sucks the flame over the tightly stacked logs,
causing them to ignite more quickly. For heavy, smooth
hardwood, larger pieces of kindling may be needed for
ignition.
CAUTION!
Never use petrol, turpentine or similar materials as an
"ignition aid": risk of explosion!
The ignition door should be kept open after
ignition to monitor the progress of the fire. It
should only be closed once the boiler's exhaust
temperature has reached 100°C.
How long it takes the fire to start depends on the type
of wood used; rough spruce may need only 2 minutes,
smooth beech may require 5 minutes until the exhaust
gas temperature reaches 100°C.
At 100°C exhaust temperature, close ignition door
and insulating door
Once a few logs are burning well and the exhaust
temperature is over 100°C, close the ignition door and
the insulating door.
Fig. 8-1: Close ignition door
Summary of Contents for TWIN 20 kW
