14
Twin is supplied with flip-up footrests,
adjustable in height and settable in
angle and depth.
Height
Loosen the locking
handle (A) on the legrest fully. Remove
the screw (B). Set the height. Replace
the screw and handle. Note: Ensure
that the screw is in the correct position
(see illustration). Tighten securely.
Angle
Loosen screws (C)
slightly. Adjust to desired angle and
tighten screws.
Tools: 5 mm Allen key
Twin can be supplied with lockable
legrests. The legrests are detachable
and can be swung to the side or under
the seat. To remove the legrests press
down on the red button (A) and lift.
To fasten the legrests press down on
the red button (B), put the legrest
into place and release the button. The
legrest is now locked, (A).
Before lifting the wheelchair
check that the legrests are
locked.
Fixed: The legrests are detachable and
can be swung to the side or under the
seat. Lockable legrests are also avail-
able.
Adjustable: In addition there are sev-
eral types of variable, angle-adjusted
legrests with calf supports. Amputee
legrests and amputee weight are also
available.
10 Settings legrests
A
B
Right Wrong
A
B
Never stand on the footrests as
you may tip the chair! Never
lift the chair by the legrests un-
less they are lockable.
10:1 Lockable legrests (option)
10:2 Height, angle and depth of the footrest
Depth
The sides of the foot-
rests have two different lengths. By
exchanging the right for the left side,
two different depths can be achieved.
For outdoor use the footrests
should be 4-5 cm above ground
level. Never stand on the foot-
rests as the chair may tip!
Make sure that the screw head
locks in the hexagon hole.
C
