21
Etac / Cross 6 / www.etac.com
20Nm
B
B
A
A
C
D
VIDEO
12. Advanced settings, customization
Height adjustment front fork attachment
Loosen the screws (A and B). Set the desired seat height by measuring
from the floor to the top of the seat post (push down the post in the
cup when measuring) and tighten the screws on one of the front fork
attachments. Use the bar markings as a reference for height adjust-
ment of the opposite side. Tighten the other attachment. Check and
adjust so that the attachmnets are vertical (see section
“Angle adjust-
ment of front fork attachment”
). Fine-tune the height of the front fork
attachments so that both wheels are on the floor.
Consider the risk of tipping.
Always check the setting of the anti-tip guard.
6 mm
20Nm
Angle setting front fork attachment
Correct angle setting is important for the wheelchair’s driving
characteristics.
Loosen the retaining screw (A) about 2 turns so that the shaft (C)
moves freely inside the sleeve.
Insert the Allen key into the hole (B) and turn until the attachment is
vertical. Always start from a position so that the wheel moves forward
in rotation (D).
Push in the sleeve and hold in the correct position while tightening
the retaining screw.
Consider the risk of tipping.
Always check the setting of the anti-tip guard.
Aim for something vertical, such as door post, table legs when
setting.
6 mm
VIDEO
