ES1050.1 Battery Pack
19
3.2.1
Preparing the ES1000.3 Housing
Fig. 3-3
Preparing the ES1000.3 Housing
To prepare the ES1000.3 Housing
1. Switch off the power supply to the housing.
Make sure that all devices connected to the
housing by cable are switched off.
When carrying out the steps listed below, look
at Fig. 3-3 on page 19.
2. Unscrew the two mounting screws at the back
of the top cover.
3. Slide the top cover out to the back and
remove it from the housing.
4. Turn the top cover upside down so that the
external side is now facing downwards.
5. Slide the top cover in the front of the frame on
the underside of the housing.
6. Tighten the two mounting screws of the cover
into the housing.
1
2
3
4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com