Operation
27
4
Operation
4.1
Inserting VMEbus boards
Some VMEbus boards have to be configured before they can be inserted. For
more information, consult the relevant board manual.
To insert a board
1. Switch off the power supply to the housing.
Make sure that all devices connected to the
housing by cable are powered off too.
2. If the slot you want to use for the board is pro-
tected by a cover, remove it.
3. Insert the board into the slot. Make sure that
the board runs in both the top and bottom
guide rails.
4. Slide the board in until the connector snaps in.
5. Screw in the mounting screws for the front
panel of the board.
6. Establish any necessary cable connections to
the connectors of the front panel.
Note
The boards can only be configured and installed at a workplace that is pro-
tected against static discharge.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com