33
.
Fig. 3-4
Output Circuit of the PB1650DIO1.1
3.4.3
Power ON State
The output drivers are disabled in the power ON state and after a local reset.
This means there is
no
output current.
The outputs are also disabled when the power supply of the VME system is off.
3.4.4
Control Interface
The control interface generates an ID byte for the piggyback.
The ID byte for the PB1650DIO1.1 piggyback is "$EF". The ID byte can be used
to detect the equipment of the carrier board using a software program.
3.4.5
Size of the Address Range
The size of the address range occupied by the PB1650DIO1.1 in your system is
256 bytes.
The B16 jumper on the ES1650.1 Piggyback Carrier Board has to be open for
this address range size.
Out1+
Out2+
Out1/2-
100 V
100 V
1 K
W
1 K
W
Optocoupler
MJD122
MJD122
X1
PB1650DIO1.1
Summary of Contents for ES1650.1
