PB1650REL1.1 Relay Piggyback (8 Channels)
55
6
PB1650REL1.1 Relay Piggyback (8 Channels)
This section contains information about the basic features and applications of
the PB1650REL1.1 relay piggyback. A block diagram shows the schematic lay-
out of the module.
6.1
Features
This piggyback provides eight electrically isolated switches in the voltage range
up to 175 V.
The piggyback has the following features:
•
voltages up to 175 V, currents up to 250 mA
•
its own ID byte
6.2
Applications
The PB1650REL1.1 piggyback can be used in VMEbus systems as a switch in
conjunction with the ES1650.1 Piggyback Carrier Board.
Typical applications are the simulation of manual switches or the switching of
loads that cannot be switched using semiconductor switches. The
PB1650REL1.1 piggyback can also be used as an analog multiplexer.
note
Some components of the piggyback may be damaged or destroyed by electro-
static discharges. Please keep the piggyback in its storage package until it is
installed.
The piggyback should only be taken from its storage package, configured and
installed at a work place that is protected against static discharge.
note
The components, connectors, and printed lines of the piggyback may carry dan-
gerous high voltages.
These voltages may even exist when the piggyback is not installed in the VME
system or when the VME system is powered off.
Make sure that the piggyback is protected against contact during its operation.
Disconnect all connections to the ES1650.1 Piggyback Carrier Board before
removing the plug-in board from the VME system.
Summary of Contents for ES1650.1
