34
3.5
Configuration
The PB1650DIO1.1 piggyback has
no
jumpers or solder straps that need to be
configured.
3.6
Pin Assignment
The pin assignment of the ES1650.1 Piggyback Carrier Board depends on
whether the piggyback is mounted in position A (top) or in position B
(bottom).
The pin assignment for each position of the piggyback is shown in a table.
"IN" means input channel, and "OUT" stands for output channel. The
numbers indicate the channel number. "+" indicates the signal output of the
channel; "-" the ground port of the channel. Note that every two channels
share a common ground.
Signal
X1 Pin
Signal
X1 Pin
OUT1+
17
IN1+
50
OUT2+
49
IN2+
33
OUT3+
15
IN3+
48
OUT4+
47
IN4+
31
OUT5+
13
IN5+
46
OUT6+
45
IN6+
29
OUT7+
11
IN7+
44
OUT8+
43
IN8+
27
OUT1/2-
32
IN1/2-
16
OUT3/4-
30
IN3/4-
14
OUT5/6-
28
IN5/6-
12
OUT7/8-
26
IN7/8-
10
Ext. reset
supply voltage
9
Ext. reset
GND
42
Tab. 3-1
Pin Assignment of the PB1650DIO1.1 - Piggyback in Position A
(Top)
Summary of Contents for ES1650.1
