58
6.4.3
ID Byte
The ID byte of the PB1650REL1.1 piggyback is "$FC". The ID byte can be used
to detect the equipment of the ES1650.1 Piggyback Carrier Board using a soft-
ware program.
6.4.4
Size of the Address Range
The size of the address range occupied by the PB1650REL1.1 in your system is
256 bytes.
The B16 jumper on the ES1650.1 Piggyback Carrier Board has to be open for
this address range size.
6.5
Configuration
The PB1650REL1.1 piggyback has
no
jumpers or solder straps that need to be
configured.
6.6
Pin Assignment
The pin assignment of the ES1650.1 Piggyback Carrier Board depends on
whether the piggyback is mounted in position A (top) or in position B (bot-
tom).
The pin assignment for each position of the piggyback is shown in a table.
Key to abbreviations:
•
Pole: center contact
•
NC: normally closed
•
NO: normally open
The number indicates the channel number.
Signal
X1 Pin
Signal
X1 Pin
Relay 0 NC
49
Relay 0 NO
50
Relay 1 NC
48
Relay 1 NO
16
Relay 2 NC
47
Relay 2 NO
15
Relay 3 NC
46
Relay 3 NO
14
Relay 4 NC
45
Relay 4 NO
13
Relay 5 NC
44
Relay 5 NO
12
Relay 6 NC
43
Relay 6 NO
11
Tab. 6-1
Pin Assignment of the PB1650REL1.1 - Piggyback in Position A
(Top)
Summary of Contents for ES1650.1
