ES4408.1 Load Chassis - User’s Guide
27
ETAS
Pin Assignment and Display Elements
Tab. 4-2
Assignment: Slot
→
“Load
n
” Connector
To connect these loads to the PT-LABCAR, use the existing PT-LABCAR cables
“AS41LC1..3”. If to date you have simulated loads with the AS_41LC, these are
connected to the front-panel connectors of the corresponding AS_41LC.
Current Rating of the Connectors
Please note the maximum admissible current of 1 A (60 V) per pin.
4.2
“Load 1” ... “Load 6” Connectors
The connection to the special loads for simulating actuators with position feed-
back in slot 3 (“Load 1”...”Load 3”) and slot 4 (“Load 4”...“Load 5”) takes place
at these connectors.
Type: Hybrid DSUB 7W2
(male)
Fig. 4-2
“Load 1” ... “Load 6” Connectors
For details of the pin assignment with the backplane signals, refer to Tab. 4-3
on page 28 and Tab. 4-4 on page 29.
A special cable is available for connecting the loads to the PT-LABCAR (connec-
tors “Load1” ... “Load6”). See "“CBAV340.1-1” Cable" on page 39.
Current Rating of the Connectors
Please note the maximum admissible current of 7.5 A (90 V) for pins A1 and A2
, and 1 A (90 V) for pins 1...5.
Note
Please note that the connector numbering does not correspond to the slot
numbering (see the following table)!
Slot
5
6
7
8
9
10
11
Connector
Load 15 Load 14 Load 13 Load 12 Load 11 Load 10 Load 9
A1
A2
1
2
3
5
4
