ES4408.1 Load Chassis - User’s Guide
40
Accessories
ETAS
5.1.3
“
CBAV341.1-1
” Cable
This cable is used to connect the loads made available at “Load 8-1” and
“Load 8-2” to the corresponding “Load8” connector of the PT-LABCAR.
Fig. 5-3
“CBAV341.1-1” Cable
Connectors and Wiring
ES4408.1 side: 2 x Hybrid-DSUB 8W8
(female)
PT-LABCAR side: ITT Cannon CA06COM-E20-29P-B (male)
The assignment of the corresponding connectors on the ES4408.1 is described in
the section "“Load 8-1” and “Load 8-2” Connectors" on page 31; for that of
the connectors of the PT-LABCAR, refer to the PT-LABCAR User’s Guide.
The wires have a cross-section of 1.5 mm
2
.
The assignment of the signals between these two connectors is shown in Tab.
5-2 on page 42.
For information on ordering this cable, refer to the section "Order Data"
on page 46.
700 mm
300 mm
