ES5338.1 Carrier Board for Wheel Speed Sensor Simulation - User’s Guide
12
Introduction
ETAS
Connecting/Disconnecting Devices
To avoid injuries and hardware damages, please observe the following precau-
tionary measures:
• Do not apply any voltages to the connections of the ES5338.1 Carrier
Board that do not correspond to the specifications of the respective con-
nection.
• Do not connect or disconnect any devices while the ES5300.1-A Housing
or ES5300.1-B Housing or external devices are switched on. First, switch
off the ES5300.1-A Housing or ES5300.1-B Housing by shutting down the
Real-Time PC and by activating the On/Off switch at the rear, then unplug
the power plug.
• When plugging in connectors, ensure that they are inserted straight and
no pins are bent.
Maintenance
The product does not require maintenance.
Repairs
If an ETAS hardware product needs to be repaired, return the product to ETAS.
Cleaning
The product is not expected to require cleaning.
CAUTION!
In order to prevent damage to the add-on card and the LABCAR
Housing, and thereby also avoid damage to property or health,
observe the installation instructions and information contained in the
relevant User's Guides.
CAUTION!
If cards (e.g. for startup or calibration) are unlocked but not com-
pletely removed from the housing, they must be pulled out far
enough that the distance between the respective card and the back-
plane of the housing is at least 1 cm! Otherwise, contacts may be
established between the cards and lead to their destruction.
