ES5338.1 Carrier Board for Wheel Speed Sensor Simulation - User’s Guide
5
ETAS
Introduction
1
Introduction
This User’s Guide contains the description of the ES5338.1 Carrier Board for Cur-
rent Output Piggyback PB5338CURR.1-A. The ES5338.1 Carrier Board can be
populated with up to six modules of the PB5338CURR.1-A Wheel Speed Sensor
Simulation Piggyback. This combination allows simulating up to six sensors.
The ES5338.1 Carrier Board simulates the signals of active digital wheel speed
sensors that offer a speed measurement (distance measurement) of close to v =
0 km/h. This also covers the partially stricter v
min
requirements for the simulation,
e.g. of navigation systems, anti-rollback devices, parking assist systems, etc.
Two additional functions are the simulation of sensor signals following the PSI5
sensor protocol and a Direct Current Output.
This chapter contains information about the following topics:
• "Properties" on page 6
• "Basic Safety Notices" on page 8
• "Identifications on the Product" on page 13
• "CE Mark" on page 13
• "RoHS Conformity" on page 13
• "KC marking" on page 14
• "Product Return and Recycling" on page 14
• "Declarable Substances" on page 14
• "About this Manual" on page 15
CAUTION!
Some components of the ES5338.1 Carrier Board can be damaged or
destroyed by electrostatic discharges. Leave the plug-in card in its
transport packaging until it is installed.
The ES5338.1 Carrier Board and the PB5338CURR.1-A Piggyback
should only be removed, configured and installed at a workplace that
is secured against static discharges.
