ES5372.1-B 1 Slot Carrier Board for ES4455.2 and ES4456.2 - User’s Guide
13
ETAS
Introduction
Approved Cables
The signal lines must not exceed a maximum length of 3 m.
Requirements for the Installation Location
Requirements for Ventilation
Transport and Installation
To avoid damages to the hardware from electrostatic discharge, please observe
the following precautionary measures:
WARNING!
Fire hazard!
Use only approved cables for creating cable assemblies (e.g. for con-
necting the ECU and external loads). The cables used must be suitable
particularly for occurring currents, voltages and temperatures and
flame-retardant in accordance with one of the following standards
IEC 60332-1-2, IEC 60332-2-2, UL 2556/UL1581VW-1!
WARNING!
This is class A equipment. This equipment can cause radio interfer-
ence in residential areas. Should that be the case, the operator may
be requested to institute reasonable measures.
CAUTION!
The air circulation inside the ES5300.1-A housing and the ES5300.1-B
housing can be ensured only if all free slots are covered with front
plates. Otherwise, it may lead to overtemperatures and trip the over-
temperature protection of the ES5300.1-A or the ES5300.1-B. For
this reason, install front plates in all free slots!
CAUTION!
Some components of the ES5372.1-B and the ES4455.2 or ES4456.2
to be installed can be damaged or destroyed by electrostatic dis-
charges. Leave the plug-in cards in their transport packaging until
their installation.
Remove, configure and install the ES5372.1-B and the ES4455.2 or
the ES4456.2 only at a workplace secured against static discharges.
CAUTION!
In order to prevent damage to the plug-in boards and the LABCAR
housing, and thereby also avoid damage to property or health,
observe the installation instructions and information contained in the
relevant User's Guides.
