ES5372.1-B 1 Slot Carrier Board for ES4455.2 and ES4456.2 - User’s Guide
27
ETAS
Setup, Installation and Fuses
2.5
Installation / Removal of the ES5300.1-B into / from the ES5300.1-
A Housing and ES5300.1-B Housing
This chapter describes how to install of remove the ES5372.1-B into or from the
ES5300.1-A housing or into or from the ES5300.1-B housing.
WARNING!
Danger through electromagnetic radiation!
The ES5372.1-B, fitted with the ES4455.2 or the ES4456.2 and loads
connected to it, can emit electromagnetic radiation during operation
which can cause interference with the operation or damage pace-
makers or implanted defibrillators.
The ES5372.1-B may be operated only in areas where persons with
pacemakers are prohibited from entering. At the entrances to these
areas, the P007 identification, "No access for persons with pacemak-
ers or implanted defibrillators" in accordance with ISO 7010:2011
"Registered Safety Signs", must be attached and clearly legible.
Failure to observe it can lead to health hazards and even death for
persons with pacemakers and implanted defibrillators.
CAUTION!
Do not install any plug-in cards while the ES5300.1-A Housing and/or
the ES5300.1-B Housing is switched on. First, switch off the
ES5300.1-A housing and/or the ES5300.1-B Housing by shutting
down the real-time PC and by actuating the On/Off switch at the rear
side.
DANGER!
Danger from high voltages!
The components, plug connectors, conductor paths of the
ES5372.1-B and the installed ES4455.2 or ES4456.2 may have dan-
gerous voltages. These voltages can also be present when the
ES5372.1-B is not installed in the ES5300.1-A Housing or in the
ES5300.1-B Housing or the ES5300.1-A Housing or the ES5300.1-B
Housing is switched off.
Ensure that the ES5372.1-B is protected against touching it during
operation. Switch off the ES5300.1-A Housing or the ES5300.1-B
Housing and pull the power plug. Wait at least three minutes before
removing the ES5372.1-B.
CAUTION!
Some components of the ES5372.1-B and the ES4455.2 or ES4456.2
to be installed can be damaged or destroyed by electrostatic dis-
charges. Leave the plug-in cards in their transport packaging until
their installation.
Remove, configure and install the ES5372.1-B, the ES4455.2 and the
ES4456.2 only at a workplace secured against static discharges.