ETAS
Technical Data
ETK-S20.1
-
User Guide
37
As of INCA 7.1.4, a generic A2L configuration for several microcontroller fami
-
lies and ETKs is available.
This generic configuration
<[microcontroller family]_Generic_Cfg[index]>
enables measurement, calibration and bypass tasks immediately after the
release of a microcontroller.
Most likely, an update of the ETAS tool chain is not mandatory after the initial
release of an ETK. Please contact the INCA Hotline for this configuration file
and additional hints.
Operating the ETK-S20.1 with older software versions is not possible.
7.2
ETK Firmware (HDC) Update
The ETK firmware update (update of the ETK hardware definition code [HDC])
supports by the service software HSP instead of ETK Configuration Tool.
Removal of ETK or ECU is not necessary. The service software HSP is running
on the connected PC.
7.3
Data Emulation Memory and Microcontroller Support
The ETK-S20.1 uses the internal overlay RAM of all in the table listed microcon
-
trollers to emulate data in internal flash.
NOTE
Please note hints for using the ETK-S20.1 at ES89x modules (refer to chapter
4.16 on
26).
Microcontroller
Max. RAM
1)
Standby powered
TC27x-ED
1 Mbyte
Yes
TC2D5-ED
512 kbyte
Yes
TC26x-ED
512 kbyte
Yes
TC29x-ED
2 Mbyte
Yes
1)
: Max. RAM as working page (kByte)