ETK-S6.0 - User’s Guide
14
ETAS
Introduction
3
Introduction
This section contains information about the basic features and applications of
the ETK-S6.0 Interface Board (ETK = Emulator Test Probe), hints to system
requirements for operating the ETK-S6.0, and other details.
3.1
Applications
The ETK-S6.0 is an emulator probe for the Renesas SH725xx microcontroller fam-
ily. It is a typical serial ETK and is selectable by configuration for Renesas specific
AUD-II or for H-UDI microcontroller debug interface. This serial ETK can be used
for rapid prototyping applications (bypass) as well as for measurement and cali-
bration applications.
Fig. 3-1
ETK-S6.0 (left: Rev. A, right: Rev. B)
3.2
Features
• By configuration selectable serial processor interface
– Configuration type ETK-S6.0A: AUD-II interface
– Configuration type ETK-S6.0B: H-UDI interface
• JTAG debugger interface
• Serial interface to the calibration and development system (100 Mbit/s)
• AUD-II interface clock speed: 10 MHz or 20 MHz (depending of used
microcontroller)
• H-UDI interface clock speed: 20 MHz
• Concurrent use of calibration and debugging function possible (configu-
ration type ETK-S6.0A)
ETK-S6.0
Configuration
Type
Serial Interface
ETK-S6.0A
Renesas Advanced User Debugger (AUD-II) interface
ETK-S6.0B
Renesas H-UDI interface
Note
The ETK-S6.0 can be shipped in the mechanical versions revision A and revision
B. Both ETK-S6.0 versions have the same features, functions and technical
data.
Both mechanical versions can be configured to use the ECU interface either as
an AUD-II interface or as an H-UDI interface. The used microcontroller deter-
mines additionally which interface is supported by the ETK-S6.0.
