Wall-Mount Driver Installation
21
Connect the Input Power
1. Make sure power is off at the main circuit breaker.
2. See
Wire and Terminal Specifications on page 16
for specification of wire size and strip
length. Prepare the wires accordingly.
3. See
Push-In Terminal Blocks on the previous page
for general instructions on using the
push-in terminal blocks.
4. Insert the ground wire (typically green) into the terminal marked "
."
5. Insert the neutral wire (typically white) into the terminal marked "N."
6. Terminate the line (hot) wire (typically black) into the terminal marked "L."
7. Tug gently on the wires to ensure they are secure.
Output Wiring to Fixture
+
-
+
-
+
-
+
-
+
CONN4
CONN5
CONN6
CONN8
CONN9
CH1
CH2
CH3
CH4
+
_
+
_
+
_
+
_
ArcLamp Driver 150
wall-mount standard and emergency
output channel wiring detail
ArcLamp Driver 350/700 wall-mount
standard and emergency
output channel wiring detail
All four output channels are shown wired.
Power wires (line wire (hot) and neutral wire) from the installed fixture are terminated to output
terminals on the ArcLamp Driver. Termination is available for up to four uniquely addressable
outputs (channels).
Note:
Power wiring should only be installed and terminated by a qualified electrician
and should follow standard wiring installation practices.
1. Make sure power is off at the main circuit breaker.
2. See
Wire and Terminal Specifications on page 16
for specification of wire, strip length,
and terminal torque ratings. Prepare the wires accordingly.
3. Terminate neutral and line (hot) wires to an output.
a. Run a neutral wire (typically white) and a line wire (typically black) through conduit
from the fixture to the ArcLamp Driver output terminals. Output channels are labeled
LED OUT 1, LED OUT 2, LED OUT 3, and LED OUT 4 on ArcLamp Driver 150 standard
and emergency models. Wall-Mount ArcLamp Driver 350 and 700 standard and
emergency models are labeled "CH 1", "CH 2", "CH 3", "CH 4".
b. Terminate the neutral wire to the output channel “-” terminal, securing the terminal
screw onto the wire.
c. Terminate the line (hot) wire to the output channel “+” terminal, securing each
terminal screw onto the wire.
d. Tug gently on the wires to ensure they are secure.