Echoflex Installation Guide
Phase Adaptive Dimmer
Phase Adaptive Dimmer (ER6CD/ER12CD)
Page 3 of 12
Echoflex
Installation
Ensure that the junction box is clean and free of obstructions and that all
wiring is installed correctly.
Install the Controller
Mount the controller directly to the exterior of the junction box or panel
either at the electrical load or before the load in the circuit.
Review these instructions completely before installing the controller.
1. Locate the circuit breaker panel and terminate power to the circuit.
2. Remove the cover plate and other hardware from the junction box to
access the wiring.
3. Mount the controller.
4. Refer to the wiring diagram on
to connect the controller to line
power, neutral, and load wires. Use wire nuts on all connections and
individually cap any bare wires, except the orange antenna wire.
The dimmer is supplied with a wire harness that is specific to the input
voltage, either 120 VAC or 277 VAC.
a. Connect the striped green/yellow wire to the ground wire from
the breaker panel and the ground wire from the lighting load.
b. Connect the white wire to the incoming neutral wire from the
breaker panel and the neutral wire of the lighting load.
c. Connect the incoming hot wire (black 120 VAC, or brown
277 VAC) to the line input feed wire (hot) from the breaker panel.
d. Connect the red output wire to the lighting load.
5. Replace the electrical box cover plate.
6. Restore power to the circuit.
Note:
Follow applicable NEC and local electrical code
requirements when installing and powering the
controller.
Note:
Do not share the neutral wire with other loads. Connect
a dedicated neutral conductor to the electrical panel.
Note:
Do not mix fixture types on the controlled output. All
fixtures on the controlled circuit should be identical.