ETC Echoflex ER12CD, Installation Manual

Echoflex Installation Guide

Phase Adaptive Dimmer

Phase Adaptive Dimmer (ER6CD/ER12CD)

 Page 8 of 12

Echoflex

LED Drive Mode

The LED drive mode can be enabled or disabled according to the load. 

•

Enabled

 (default) - the minimum dimming level is used. Enable the 

setting for use with ELV, LED, MLV track lighting with LED loads, or 
2-wire fluorescent.

•

Disabled

 - the minimum dimming value is 0. Disable the setting for 

use with halogen or incandescent, and for MLV track lighting with 
halogen or incandescent loads.

To Disable LED drive mode:

1. Press and hold both the 

[Learn]

 and the 

[Clear]

 buttons until both the 

Power and Learn LEDs blink blue to access the dimming menu.

2. Press the 

[Clear]

 button once to access the drive mode menu. The 

Power LED remains ON solid blue and the Learn LED blinks green to 
indicate:

• 1 blink = Disabled 
• 2 blinks = Enabled (default)

3. Press and release the 

[Learn]

 button to cycle through the blink codes 

until 1 green blink displays (disabled). 

4. Press and hold the 

[Clear]

 button until the Learn LED blinks blue to 

save and exit the menu.

To Enable LED drive mode and adjust minimum dimming level:

1. Press and hold both the 

[Learn]

 and the 

[Clear]

 buttons until both the 

Power and Learn LEDs blink blue to access the dimming menu.

2. Press the 

[Clear]

 button once to access the drive mode menu. The 

Power LED remains ON solid blue and the Learn LED blinks green to 
indicate:

• 1 blink = Disabled 
• 2 blinks = Enabled (default)

3. Press and release the 

[Learn]

 button to cycle through the blink codes 

until 2 green blinks display (enabled). 

4. Press the 

[Clear]

 button once to access the levels menu. The Power LED 

remains ON solid blue and the Learn LED is ON solid red. 

5. Press and release the [

Learn] 

button to increase the minimum 

dimming level by 5% increments. The default dimming level is 20%. 
The levels wrap around to 0% once 100% is reached.

6. Press and hold the 

[Clear]

 button until the Learn LED blinks blue to 

save and exit the menu.

The dimming menu times out after 30 seconds of inactivity.